Manuale installatore - Installer manual Art. 69DV - 69DV/5 Divisore di montante per impianti Due Fili Elvox Riser splitter for Elvox Two-Wire installations
Descrizione - Description Il divisore di montante 69DV, e un accessorio per impianti Due Fili Elvox che permette di sezionare un montante. Ogni divisore di montante permette la derivazione di 4 colonne. - Il concentratore art. 69DV e progettato per l uso di cavo con impedenza caratteristica di 00 Ohm. - Il concentratore art. 69DV/5 e progettato per l uso di cavo con impedenza caratteristica di 50 Ohm. The 69DV riser splitter accessory for Elvox Two-Wire installations can be used to create sections along a riser. Each riser splitter allows the branching of 4 columns. - Concentrator 69DV is designed for use with a cable with characteristic impedance of 00 Ohm. - Concentrator 69DV/5 is designed for use with a cable with characteristic impedance of 50 Ohm. Caratteristiche tecniche - Technical characteristics Codice code Assorbimento stand by Input current Assorbimento massimo Maximum input current Attenuazione passante Loop loss Attenuazione derivata Branch loss 69DV 5 ma 50 ma 0, db 0 db 69DV/5 5 ma 50 ma 0, db 0 db Codice code Cavo previsto Recommended cable Cavo previsto per uso interrato o dove richiesto LSZH Cable recommended for underground use or where LSZH is required Cavo utilizzabile Usable cable 69DV Elvox Elvox LSZH - 69DV/5 - - Cat 5 Terminazione del connettore di ingresso - Input connector termination Uscite derivate - Branch outputs Terminazione Termination Nessuna terminazione No termination Strip di terminazione termination strip ON OFF Ingresso montante Riser input Ingresso montante Riser input Uscita passante montante Riser loop output IN= Ingresso montante Riser input OUT = Uscita passante montante Riser loop output
Ingresso - Input: In Uscita passante - Loop output: Out Uscite derivate - Branch outputs: Out, Out, Out3, Out4 Morsettiere - Terminal block Nota: corrente massima transitabile dai morsetti In ai morsetti Out o Out o Out3 o Out4 è di 0,8A. Note:The maximum current that can flow from In terminals to Out, Out, Out3 or Out4 terminals is 0.8 A. Nota: possono essere collegati al massimo divisori di montante con collegamento entra/esci (rif. schema SI68 e SI684) Note: only two riser splitter can be connected with in / out connection (ref. scheme SI68 and SI684) Installazione - Installation - Apparecchio installabile su guida EN500 o parete tramite viti e tasselli in dotazione, ingombro 4 moduli, dimensioni 7 x 0 x 60 mm. - Device can be installed on EN500 rails or wall mounted using the screws and expansion plugs provided, equivalent size of 4 modules, dimension 7 x 0 x 60 mm. 3
SI68 Montante/Riser Montante/Riser Montante/Riser 3 Montante/Riser 4 = cavo twistato twisted cable F = alimenatatore di sistema System power supply = divisore di montante Riser splitter RETE MAINS F B B Unità elettronica/electronics unit Montante/Riser Montante/Riser 4 Montante/Riser 6 Montante/Riser 8 Montante/Riser Montante/Riser 3 Montante/Riser 5 Montante/Riser 7 RETE MAINS F B B Unità elettronica/electronics unit SI68 4
Mont./Riser Mont./Riser 4 Mont./Riser Mont./Riser 3 Mont./Riser 6 Mont./Riser 8 Mont./Riser 5 Mont./Riser 7 Mont./Riser 0 Mont./Riser Mont./Riser 4 Mont./Riser 6 Mont./Riser 9 Mont./Riser Mont./Riser 3 Mont./Riser 5 = cavo twistato Twisted cable F = alimenatatore di sistema System power supply = divisore di montante Riser splitter RETE MAINS F B B Unità elettronica/electronic unit SI683 5
Mont./Riser Mont./Riser 4 Mont./Riser 6 Mont./Riser 8 Mont./Riser Mont./Riser 3 Mont./Riser 5 Mont./Riser 7 Mont./Riser 0 Mont./Riser Mont./Riser 4 Mont./Riser 6 Mont./Riser 9 Mont./Riser Mont./Riser 3 Mont./Riser 5 = cavo twistato Twisted cable F = alimenatatore di sistema System power supply = divisore di montante Riser splitter J = Concentratore Concentrator RETE MAINS F B B IN B B OUT J OUT IN I IN4 B B B B B B Unità elettroniche/electronic Units SI684 6
AVVERTENZE PER L INSTALLATORE - Leggere attentamente le avvertenze contenute nel presente documento in quanto forniscono importanti indicazioni riguardanti la sicurezza di installazione, d uso e di manutenzione. - Dopo aver tolto l imballaggio assicurarsi dell integrità del l apparecchio. Gli elementi dell imballaggio (sacchetti di plastica, polistirolo espanso, ecc.) non devono essere lasciati alla portata dei bambini in quanto potenziali fonti di pericolo. L esecuzione dell impianto deve essere rispondente alle norme CEI vigenti. - Questo apparecchio dovrà essere destinato solo all uso per il quale è stato espressamente concepito. Ogni altro uso è da considerarsi improprio e quindi pericoloso. Il costruttore non può essere considerato responsabile per eventuali danni derivanti da usi impropri, erronei ed irragionevoli. - In caso di guasto e/o di cattivo funzionamento dell apparecchio, togliere l alimentazione mediante l interruttore e non manometterlo. Per l eventuale riparazione rivolgersi solamente ad un centro di assistenza tecnica autorizzato dal costruttore. Il mancato rispetto di quanto sopra può compromettere la sicurezza del l apparecchio. - L installatore deve assicurarsi che le informazioni per l utente siano presenti sugli apparecchi derivati. Direttiva 00/96/CE (WEEE, RAEE) Il simbolo del cestino barrato riportato sull apparecchio indica che il prodotto, alla fine della propria vita utile, dovendo essere trattato separatamente dai rifiuti domestici, deve essere conferito in un centro di raccolta differenziata per apparecchiature elettriche ed elettroniche oppure riconsegnato al rivenditore al momento dell acquisto di una nuova apparecchiatura equivalente. L utente è responsabile del conferimento dell apparecchio a fine vita alle appropriate strutture di raccolta. L adeguata raccolta differenziata per l avvio successivo dell apparecchio dismesso al riciclaggio, al trattamento e allo smaltimento ambientalmente compatibile contribuisce ad evitare possibili effetti negativi sull ambiente e sulla salute e favorisce il riciclo dei materiali di cui è composto il prodotto. Per informazioni più dettagliate inerenti i sistemi di raccolta disponibili, rivolgersi al servizio locale di smaltimento rifiuti, o al negozio in cui è stato effettuato l acquisto. Rischi legati alle sostanze considerate pericolose (WEEE) Secondo la nuova Direttiva WEEE sostanze che da tempo sono utilizzate comunemente su apparecchi elettrici ed elettronici sono considerate sostanze pericolose per le persone e l ambiente. L adeguata raccolta differenziata per l avvio successivo dell apparecchio dismesso al riciclaggio, al trattamento e allo smaltimento ambientalmente compatibile contribuisce ad evitare possibili effetti negativi sull ambiente e sulla salute e favorisce il riciclo dei materiali di cui è composto il prodotto. Il prodotto è conforme alla direttiva europea 004/08/CE e successive. WARNINGS FOR THE INSTALLER - Carefully read all instructions and warnings in this document as they provide important information regarding safety during installation, operation and maintenance. - After removing the packaging, check the condition of the device. Packaging materials (plastic bags, expanded polystyrene, etc.) must be kept out of the reach of children as they constitute a hazard. System installation must comply with current CEI standards. - This device must only be used for the purpose for which it was expressly designed. Any other use is considered improper and therefore hazardous. The manufacturer declines all liability for damage caused by improper, incorrect or unreasonable use. - In the event of faults and/or malfunctions, disconnect the device from the power supply immediately by means of the switch and do not tamper with any of its parts. For repairs, only contact service centres authorised by the manufacturer. Failure to observe the above may impair equipment safety. - The installer must ensure that user information is applied to device extensions. 00/96/EC Directive (WEEE) The crossed-out dustbin symbol on the equipment indicates that the product, at the end of its useful working life, must be disposed of separately from normal household waste, and as such must be taken to a waste separation and recycling centre equipped to deal with electric and electronic equipment or sent back to the dealer when new replacement equipment is purchased. The user is responsible for ensuring the equipment is disposed of via the correct channels when it is no longer in working order. Suitable separated waste collection for subsequent recycling, processing and environmentally conscious disposal of the old appliance helps to prevent negative impact on the environment and human health while encouraging recycling of the materials used to build the product. For more detailed information regarding the available waste collection systems, contact your local waste disposal service or the shop from which the equipment was purchased. Risks associated with substances considered hazardous (WEEE) According to the new WEEE Directive, substances which for some time have been widely used in electrical and electronic equipment are considered hazardous to human heath and the environment. Suitable separated waste collection for subsequent recycling, processing and environmentally conscious disposal of the old appliance helps to prevent negative impact on the environment and human health while encouraging recycling of the materials used to build the product. Product is according to EC Directive 004/08/EC and following norms. 7
Via Pontarola, 4/a 350 Campodarsego PD Tel. +39 049 90 5 Fax +39 049 90 603 www.elvox.com S6I.69D.V00 RL. 00 3 05 ELVO - Campodarsego - Italy