SAMAR OFFERTA SPECIALE OSCILLOSCOPI * 500/350/250/150MHz with 2/4 Channels * 5GSa/s RT or 100GSa/s ET Sampling Rate * Independent Memory for Each Channel * VPO Technology * Large 8-inch 800x600 Display * Split Screen Function * 3 Built-in Impedances (50Ω/75Ω/1MΩ) * Power Analysis Software (Optional) * Serial Bus Analysis Software for I2C, SPI and UART (Optional) RS-232 - USB GPIB VGA OUTPUT - PC SOFTWARE LABVIEW DRIVER PICTBRIDGE - LAN GDS-3154 150MHz 4CH EURO: 1606.00 + IVA GDS-3254 250MHz 4CH EURO: 1887.00 + IVA GDS-3152 150MHz 2CH EURO: 1606.00 + IVA GDS-3252 250MHz 2CH EURO: 2817.00 + IVA GDS-3504 500MHz 4CH EURO: 4448.00 + IVA
100/70/50 MHz Bandwidth with 2 Input Channels * 250MSa/s Real-Time and 25GSa/s Equivalent-Time Sampling * 4k Memory Length per Channel * Peak Detect as Fast as 10ns * Save/Recall of 15 Front Panel Settings & Waveforms * 5.7" TFT Color Display * 19 Auto Measurements * Arithmetic Operators - Add, Subtract, FFT * USB Port for PC Connection * Data Logger * Limited Lifetime Warranty USB - AUTOTEST PC SOFTWARE LABVIEW DRIVER GDS-1052-U 50MHz EURO: 283.00 + IVA GDS-1072-U 70MHz EURO: 320.00 + IVA GDS-1102-U 100MHz EURO: 384.00 + IVA * 150/100/70MHz Bandwidths * 1GSa/s Real-Time Sample Rates Maximum, 25GSa/s Equivalent-Time * 2Mega Points Record Length * 2mV~10V Vertical Scale * 1ns~50s Horizontal Range GDS-1072A-U * Up to 27 Automatic Measurements * 5.7" TFT LCD Display * USB Host and Device Interface Supported * Go/NoGo Function * Data Logger * Limited Lifetime Warranty USB - AUTOTEST PC SOFTWARE LABVIEW DRIVER - PICTBRIDGE 70MHz EURO: 384.00 + IVA GDS-1102A-U 100MHz EURO: 512.00 + IVA GDS-1152A-U 150MHz EURO: 640.00 + IVA ANALIZZATORE STATI LOGICI IN ABBINAMENTO A OSCILLOSCOPIO DIGITALE * 32/16 Input Channel * Time Analysis : Up to 200MHz Internal Sampling Rate * State Analysis : Up to 100MHz External Input Clock * Memory Depth : Up to 2Mbits/1Mbits (Half/Full Channels) * Enable Qualifier : High/Low Level Enable and Enable Delay Function * Signal Analyzer : I2C, RS-232C Protocol Analyzer and Signal Statistics * File Export : Signal Data, Operation Setting and Display Image * USB 2.0 Supported(1.1 Compatible)
ANALIZZATORE DI SPETTRO
SAMAR s.r.l. Web: www.samar-instruments.it ANALIZZATORE DI SPETTRO - Frequency Range: 9kHz ~ 3GHz - High Frequency Stability: 25ppb (0.025ppm) - RBW: 10Hz ~ 10kHz in 1-3 steps, 10kHz ~ 1MHz in 10% adjustable steps - Phase Noise: -88dBc/Hz @1GHz, 10kHz Offset - Built-in Measurement Functions: Channel Power, N-dB bandwidth, OCBW, ACPR, SEM, TOI, CNR, CTB, CSO - Built-in Spectrogram and Topographic Display Modes - Gate Sweep Function - 1Hz Resolution Marker Counter - AM/FM Demodulation Analysis - 886MHz IF Output for User s Extended Applications - Various Interface: USB Host/Device, RS-232, LXI, Micro SD, GPIB (Optional) - 8.4" large TFT LCD display with SVGA resolution of 800 *600 - DVI-I Output for External Digital Display - Built-in Preamplifier, 50dB Attenuator, and Sequence Function - Optional 6GHz Power Sensor, Tracking Generator, Battery Back RS-232 - USB GPIB VGA OUTPUT AUTOTEST COUNTER - PC SOFTWARE SD CARD SDHC - LAN GSP-930 EURO: 4722.00 + IVA RF TRAINER APPLICAZIONI WIRELESS VAT- P.I. e C.F. : 00862920154. N.. iscrizione....registro...produttori... AEE:.. IT08020000001267... rev11.12
GENERATORE DI FUNZIONI AFG-2105 EURO 285.00 + IVA
SFG-2110 EURO 354.00 + IVA
MULTIMETRO GDM-8261 EURO 657.00 + IVA
GDM-461 EURO 66.00 + IVA MILLIOHMMETRO 30000 Counts Display High Accuracy 0.05% Hi/Lo Comparator and Limit Percent Setting Measurement of REL, Actual and % Value Continuous or Triggered Measurement Mode Temperature Compensation and Measurement Four-Terminal Measurement Technique Auto-Recall Last Setting After Power OFF and ON Again Alarm Setting for PASS/FAIL Scan, Handler Interface(Standard) Manual or Autoranging RS-232C+GPIB (Option) LABVIEW DRIVER GOM-802 EURO 365.00 + IVA
PROVE SICUREZZA ELETTRICA Touch Panel with Color LCD Display 9 Different Measurement Network to Simulate the Resistance of Human Body 8 Different Types of Leakage current for Medical & General Electrical Equipment Various Leakage Current Measuring Mode: DC/AC/AC+DC/AC Peak Upper & Lower Limitation for PASS/FAIL Judgment Meter Mode with SELV/CONV Function 50 Preset Test Conditions Conform to IEC 60990; 30 Sets Memories for Customer Defined Various Standard Interfaces: RS232/GPIB/USB Host & Device/EXT I/O GLC-9000 EURO 1663.00+ IVA 200VA AC Test Capacity 240x64 Ice Blue Dot matrix LCD Manual/Auto Mode Function Key for quick selecting High intensity flash for Caution & Status indication Safety INTERLOCK function Zero Crossing Turn-on Operation GPT-9804 EURO 1630.00+ IVA Controllable Ramp-up Time True RMS Current Measurement High resolution: 1uA for measuring current, 2V for setting voltage PWM amplifier to enhance the power efficiency and reliable testing Max. 100 memory block for test condition (step) setting. And each step can be named individually. Remote terminal on the front panel for start and stop control Interface : RS-232C, USB device, Signal I/O and GPIB (optional)
PROVA COMPONENTI LCR SERIE 800 Test Frequency: 12Hz~200kHz (LCR-821) 12Hz~100kHz (LCR-819/829) 12Hz~10kHz (LCR-817/827) 100Hz~2kHz (LCR-816/826) 0.05%~0.1% Basic Accuracy 100 Sets Memory for Save/Recall of Settings R/Q, C/D, C/R, L/Q, Z/θ, L/R Test Modes Absolute Value, Value, and % Measurement Display 240 x 128 dot Matrix LCD Display Displays Condition and Test Result Simultaneously Interface: RS-232C (LCR-821/819/817/816)/ Handler (LCR-829/827/826) * 20,000/2,000 Counts Dual Display * Test Frequency : 100/120Hz/1/10/100kHz * Auto LCR Mode for DUT Measuring * 0.2% Basic Accuracy * Measurement Parameter : L,C,R,D,Q,ESR,θ,DCR * Parallel/Series Testing Mode * Sorting Mode for Quality Control * 2Wire or 5Wire Measurement Available * Data Hold and Zero Mode Supported * Max/Min * Auto Range, Auto Backlit * Low Battery Indication * Auto Power off * Data Collection/AC power operation LCR-916 EURO 275.00 + IVA
ALIMENTATORE STABILIZZATO alimentatori stabilizzati singolo 0-30V 0-5A singolo 0-30V 0-10A singolo 0-30V 0-5A singolo 0-100V/0-30A doppio 2x(0-30V) 2x(0-5A) triplo 2x(0-30V) 2x(0-5A)+5V/1A quadruplo 2x(0-30V) 2x(0-5A)+15V/1A+6,5V/3A ac/dc alimentatori ac/dc 0-30V 0-6A dc 0-30V 0-5A 5V/3A ac0-250v 2,5A dc 0-30V 0-5A 5V/3A ac0-250v 5A ALIMENTATORI ALTA TENSIONE Sorgente di alta tensione flottante, ad impiego universale, per il funzionamento di tubi elettronici. Con trasformatore incorporato resistente alle alte tensioni, che consente di prelevare la tensione di riscaldamento necessaria per azionare i tubi elettronici. Alta tensione a regolazione continua, non pericolosa, con limitazione della corrente passiva e display analogico della tensione. Collegamenti: jack di sicurezza da 4 mm Alimentazione: 220-240V ca ± 10% 50/60Hz Dimensioni: 132x170x270 mm peso 2Kg